TEC CB-426-T3 Owner's Manual page 108

A5.4 Parameter
Setting (Cont.)
Note:
Use the FEED or RESTART key
to enter a desired option.
Note:
The ribbon type can also be changed
in the printer properties on the
computer. See Section 3.8.2.
100
Specifying the Print Head to be Used
PM ADJUST
Press the PAUSE key.
After "PM ADJUST" appears, press the FEED key.
HEAD SELECT
To select which print heads will be used, press the PAUSE key.
HEAD1
Select "ON" to use Head 1. Otherwise "OFF" will disable the
head.
After making a selection, press the PAUSE key.
HEAD2
Make a selection for Head 2 in the same manner.
After making the selection, press the PAUSE key, and the message
returns to "<2> PARAMETER SET".
Specifying the Ribbon Type to be Used
HEAD SELECT
Press the PAUSE key.
After "HEAD SELECT" appears, press the FEED key.
RIBBON
The ribbon type for each color can be selected. Press the PAUSE
key.
HEAD1
Select which ribbon will be used for Head 1: F1 (Hot Release
Ribbons) or P1S (Cold Release Ribbons).
After selecting the ribbon type, press the PAUSE key.
HEAD2
Select the ribbon type for Head 2 in the same manner.
After selecting the ribbon type for both colors, press the PAUSE
key. The message returns to "<2> PARAMETER SET".
Appendix 5
ON
ON
F1
F1
System Mode