Toshiba B-850 Owner's Manual page 94

APPENDIX 4 SYSTEM MODE
A4.5 Test Print (Cont.)
Print Sample of Characters
Print Sample of Barcodes
NOTE:
The Non-Printing function
simply looks like a media
feed.
Print Sample of Non-print
NOTES:
Factory test print conditions:
One paper feed, Slant lines
(3 dots), Bar codes,
Characters, Item count: 5
pcs. each, Print speed:
4"/sec., Sensor type: Black
mark (Lower side) or Feed
gap sensor
When the feed gap sensor is
selected, a gap length is 3
mm.
Print method: Thermal
transfer, Issue mode: Batch
printing (without cut), Label
length: 76 mm, Print tone fine
adjustment.
Characters
While selecting the Characters, press the [PAUSE] key to start printing
the characters. After printing is completed, the display returns to
"<4>TEST PRINT".
Pressing the [PAUSE] key causes the display to show "CHARACTERS"
again. Then, press the [FEED] key.
Barcode
While selecting the Barcode, press the [PAUSE] key to start printing
the bar codes. After printing is completed, the display returns to
"<4>TEST PRINT".
Pressing the [PAUSE] key causes the display to shown "BARCODE"
again. Then, press the [FEED] key.
Non-Printing
While selecting the Non-printing, press the [PAUSE] key to start
issuing a blank page of media. After printing is completed, the display
returns to "<4>TEST PRINT".
Pressing the [PAUSE] key causes the display to shown "NON-
PRINTING" again. Then, press the [FEED] key.
Factory Test
While selecting the Factory test, press the [PAUSE] key to start
printing the factory test pattern. After printing is completed, the display
returns to "<4>TEST PRINT".
Pressing the [PAUSE] key causes the display to indicate "FACTORY
TEST" again. Then, press the [FEED] key.
mark (Lower side) or Feed
A4-18
EO1-33029
A4.5 Test Print