A1.2 Options; A1.3 Media; A1.3.1 Media Type - Toshiba B-850 Owner's Manual

APPENDIX 1 SPECIFICATIONS

A1.2 Options

Option Name
Cutter module
PCL5 interface board
Expansion I/O
interface board
Keyboard module
PCMCIA interface
board
NOTE:
Available from your nearest TOSHIBA TEC representative or TOSHIBA TEC Head Quarters.

A1.3 Media

Please make sure that the media that will be used is approved by TOSHIBA TEC. The warranty does not apply
when a problem is caused by using media that is not approved by TOSHIBA TEC.
For information regarding TOSHIBA TEC-approved media, please contact a TOSHIBA TEC authorized service
representative.

A1.3.1 Media Type

Two types of media can be loaded for this thermal transfer/direct thermal printer-label or tag. The table below
shows size and shape of the media available for this printer.
Stop
position
Cut position
Type
B-7208-QM A stop and cut swing cutter.
B-7708-PCL-QM This board enables the B-852 printer to support the
HP-PCL5.
B-8700-IO-QM Installing this board in the printer will allow a
connection with an external device with the
exclusive interface, such as the keyboard module.
KB-80-QM This module is an external intelligent keyboard unit,
including a 16 digit by 2 line LCD and 28 key
switches.
B-7708-PC-QM This board enables the use of the following
PCMCIA cards:
LAN card: 3 COM EtherLink® III (recommended)
ATA card: Conforming to PC card ATA standard
Flash memory card: 4MB card (See page 2-14.)
Black Mark
(on reverse side) Refer to
Label
NOTE 3 below.
Description
Stop
position
Cut position
Feed Direction
A1- 2
A1.2 Options
See NOTE.
See NOTE.
See NOTE.
See NOTE.
See NOTE.
Black Mark
Tag paper
(on reverse side)
EO1-33029
Source