Toshiba B-850 Owner's Manual page 83

APPENDIX 4 SYSTEM MODE
A4.4 Printer Parameter
Fine Adjustment
(Cont.)
Cut Position Fine Adjustment
(Example)
NOTES:
Cut issue is available only
when the optional cutter unit
(B-7208-QM) is installed.
When you need the cutter,
please contact your nearest
TOSHIBA TEC service
representative.
The fine adjustment value
equals the sum of the fine
adjustment values set by the
PC command and this
parameter.
The maximum cut position
fineadjustment value is
±50.0mm. When the value
reaches the maximum, the
value remains unchanged
even if the subsequent fine
adjustment is performed.
Cut Position Fine Adjustment
With this parameter you can fine adjust the cut position.
"<3>ADJUST SET" appears, press the [PAUSE] key twice.
[RESTART]
[FEED]
[FEED] key: Pressing the [FEED] key one time causes a –0.5mm
change, up to –50.0 mm.
[RESTART] key: Pressing the [RESTART] key one time causes a
+0.5mm change, up to +50.0 mm.
After completing the fine adjustment, press the [PAUSE] key.
A4- 7
A4.4 Printer Parameter Fine Adjustment
EO1-33029
When