Head/Carriage Assembly Removal (Type 1 And Type 2D Drive); Pulley And Drive Band Removal - IBM 6360 Product Support Manual

Head/Carriage Assembly Removal
(Type 1 and Type 20 Drive)
CAUTION
When a diskette drive is removed from
its mounting, verify the ground
through the AC connector. Check
for 0 ohms between the diskette unit
base and the diskette drive.
1. Turn the system power off.
2. Remove the Read/Write head cable
from the file control card and
cable guide.
3.
Remove the cable guide.
WARNING: The head
carriage
band must not be bent or dam-
aged.
4.
Remove the carriage bracket from
the head carriage band
O.
5.
Loosen
the two top guide rod
screws O.
6. Slide the top guide rod to the
left and remove the head carriage
assembly
f) .
Pulley and Drive Band Removal
CAUTION
When a diskette drive is removed from
. its mounting, verify the ground
through the AC connector. Check
for 0 ohms between the diskette unit
base and the diskette drive.
1. Turn the system power off.
2. Remove the head cable connector
and cable guide.
WARNING: The drive band is eas-
ily damaged. (Do not bend,
crease or scratch the drive
band. )
3. Remove the three mounting screws
and clamps that attach the band to
the pulley and carriage
0 .
4. Remove the stepper pulley and
pulley clamp • .
7-40 IBM Displaywriter Product Support Manual