Collet/Flat Spring Removal - IBM 6360 Product Support Manual

Collet/Flat Spring Removal
WARNING: Do not attempt to remove
the collet/flat spring before removing
the bail. Too much pressure or bind-
ing can damage the spring.
1. Turn the system power off.
2. Close the diskette handle.
3. Push the bail slightly, and dis-
connect the bail actuator cable
from the bail cable stud
0'.
4. Open the diskette handle.
WARN ING: Damage to the head
can occur if the pressure pad is
permitted to hit it.
5. Remove the diskette handle.
6. Observe the position of the bail
return spring, and loosen the bail
retainer screw. Pivot the
retainer down ' . .
7 . Remove the bail, the bail return
spring, and the pivot rod
0
8. Remove the collet actuator roll
and the pressure roll
O.
9. Turn the collet actuator rod up
and out of the way.
WARN I NG: Do not put too much
pressure on the flat spring.
10. Remove the collet/flat spring
assembly
O.
11. Remove the collet actuator rod.
~
I
I
Chapter 7. Diskette Unit 7-33