Fly Plate Replacement (Type A Only) - IBM 6360 Product Support Manual

Fly Plate Replacement (Type. A only)
Reinstalling a disconnected fly plate
in a key module is not recommended.
If replacement is necessary because a
new key module is not available,
inspect: the fly plat:e to ensure the
connection is not loose between the
spring and fly plate and that the fly
plat~ is not damaged.
1. Disassemble the keyboard (see Pad
Card Removal)
2. Remove the key module (see Key
Module Removal).
3. Form the spring on the fly plate
so there is 12.7 mm (0.5 inch)
between the ends of the spring
O.
4. Tape the key stem down as shown
e.
Metric
I
5. Hold t~e key module and fly plate
as shown, line up the ends of the
fly plate spring with the tips of
the flat spring attached to the
key stem.
6. Insert a small stylus or straight-
ened paper clip thrqugh one of the
access· holes i~ the ~ey module
•••
7. Pu~h the tip of the flat spring up
on the inside of the fly plate
spring
0 .
8.
Move the flat spring down until
the tab drops into the opening of
the fly plate spring
O.
9. Attach the other end of the spring
in the same way.
10. Carefully remove the tape holding
the key stem.
11. Check the key stem insert for
taper in the center opening and
form if necessary
O.
correct. •
~.
12. Install the key module in the key
assembly frame.
13.
Reassemble keyboard and replace
the keybutton.
5-20 IBM Displaywriter Product Support Manual