Bail Solenoid And Idler Removal - IBM 6360 Product Support Manual

Bail Solenoid and Idler Removal
CAUTION
When a diskette drive is removed from
its mounting. verify the ground
th rough the AC con nector. Check
for 0 ohms between the diskette unit
base and the diskette drive.
1. Turn the system power off.
2. Disconnect the bail actuator cable
from the bail cable stud .
•
3. Remove the solenoid cable connec-
tor from the file control card.
4. Remove the AC motor dr i ve be 1 t
o.
5. Remove the solenoid, bracket and
cable as a unit
e ..
6. Remove the idler • .
7. Loosen the solenoid locking
setscrew and unscrew the solenoid
from the bracket
G.
Chapter 7. Diskette Unit 7-37