Positioning The On-Screen Display; Adjusting The Scancode Set Of The Ps/2 Keyboard - G&D miniMUX4 Installation And Operation Manual

Configuration

Positioning the On-Screen Display

In the default configuration, the On-Screen Display of the KVM switch is displayed
in the middle of the console monitor. However, you can adjust the position to your
needs.
How to change the position of the On-Screen Display:
1. Press
Ctrl+Num
2. Press to open the
F1
3. Use the
Arrow keys
4. Use the Arrow keys
5. Press the Arrow keys
6. Press or the left mouse key.
Enter
7. Press to save your settings.
F1

Adjusting the scancode set of the PS/2 keyboard

IMPORTANT: Only the Supervisor can change this setting.
If you press a key at the PS/2 keyboard, the keyboard processor sends a data packet
that is called scancode. The two common scancode sets (sets 2 and 3) contain differ-
ent scancodes.
In the default configuration, the user module interprets any entry made at the PS/2
keyboard with the scancode set 2.
Use the scancode set 3 if you cannot enter the pipe "|" or the Arrow keys do not
work as expected.
34 · G&D miniMUX4
(standard) to open the On-Screen Display.
menu.
Function
to select
Console Setup
to select Menu Position
MENU POSITION
Esc
or the mouse to move the menu to the desired position.
and press
Enter
and press Enter
miniMUX4
Enter F1:Save
.
.