Levelling The Washer - Fisher & Paykel WH1060P1 Installation Instructions Manual

The exact height of your washer is dependent on how far the feet are extended from the base of the
machine. The space where you install your washer needs to be at least 40mm wider and 20mm
deeper than its dimensions.
• Electrical supply: 220 – 240V, 50Hz sinusoidal, minimum 10A.
• Inlet water static pressure: Max. 1MPa (150psi), Min. 30kPa (4.5psi).
• Inlet water flow rate at tap: Min. 6 litres/min.
Location
Install the machine on a solid and level floor surface ensuring it has at least 20mm clearance on each
side. The washer must not be installed on any soft or textured floor coverings (eg carpet, rugs).
This machine must not be installed and operated on a plinth.

Levelling the Washer

Level the washing machine to ensure good spin performance, and to minimise noise, vibrations and
wear and tear on the washer.
1. Before positioning the washer in its final position, check that it
is level, front to back and side to side.
2. Adjust the washer into its final position (we suggest a minimum
clearance of 20mm each side).
3. Use a spirit level to check that the washer is correctly level. If
needed, pull the washer out. Loosen the lock nut using the
https://producthelp.fisherpaykel.com/au/Wash/Front_Loaders/WashSmart/WH1060P1/User_Guide_WH1060P1/03_Installatio...
Updated: Mon, 06 Apr 2020 08:08:16 GMT
Powered by
6