Installing Accessories - Culligan High Efficiency 1.5 Twin Series Installation, Operation And Service Instructions

Table of Contents

Aqua-Sensor

(P/N 01025279)

Aqua-Sensor

probe detects and initializes a regeneration based on exhaustion of the resin bed, which is monitored by

electrical conductivity. The conductivity is also monitored in the resin during regeneration to determine the brining process

has been complete and to optimize the slow rinse times, potentially saving water.

WARNING! For best results, do not subject the Aqua-Sensor® to conditions outside the operat-

Adjust the cable to the proper length for the HE tank size. The small center plug can be loosened to allow cable move-

ment and then retightened with pliers to prevent leaks. Remove the Fillport plug by turing it a 1/4 turn and lifting up on the

plug. Lube the o-ring of the Aqua-Sensor probe plug before inserting it into the port.

NOTE

After installation of the Aqua-Sensor probe, a complete regeneration is required to set the probe at its

proper depth, and record the conductivity in the tank. Refer to GBE Programming for Commercial Soft-

eners and Filters (except for HFxN) Manual (P/N 01027295) for programming information. This manual

can be obtained from your local dealer, CPort (www.cport.culligan.com) under the

Tab

or on the Service Tech App.

NOTE

Aqua-Sensor probe requires the connection of the 2.5V power cord to the transformer and circuit

board. See

page 20

Softener Model

Recommended "A"

NOTE

Measurement to the bottom of the probe allows for a 30% reserve capacity.

Aqua-Sensor probe should

be completely within the

resin bed.

Cat. No. 01024821

ing parameters of the water softening system. See

for details.

HE-60

HE-90

37.5"

42.6"

NOTE

1" minimum from bottom of

probe to gravel bed.

Bottom of Resin Bed

Gravel Underbedding

Figure 33.

Aqua-Sensor