Before Using - Hitachi C 12LSH Handling Instructions Manual

BEFORE USING

1. Make sure the power source is appropriate for the tool.
WARNING
Never connect the power tool unless the available AC power source is of the same
voltage as that specifi ed on the nameplate of the tool.
Never connect this power tool to a DC power source.
2. Make sure the trigger switch is turned OFF.
WARNING
If the power cord is connected to the power source with the trigger switch turned
ON the power tool will start suddenly and can cause a serious accident.
3. Check the saw blade for visible defects.
Confi rm that the saw blade is free of cracks or other visible damage.
4. Confi rm that the saw blade is attached securely to the power tool.
Using the supplied 17 mm box wrench, tighten the 10 mm bolt on the saw blade spindle to
secure the saw blade.
For details, see Fig. 54-a, Fig. 54-b, Fig. 54-c and Fig. 54-d in the section on "SAW
BLADE MOUNTING AND DISMOUNTING" on page 82.
5. Check the lower guard for proper operation. (Fig. 6)
Lower guard is designed to protect the operator
from coming into contact with the saw blade during
operation of the tool.
Always check that the lower guard moves smoothly
and covers the saw blade properly.
WARNING
NEVER OPERATE THE POWER TOOL if the lower
guard does not function smoothly.
6. Confi rm the position of the spindle lock before using the tool.
After installing the saw blade, confi rm that the spindle lock has been returned to the retract
position before using the power tool (see Fig. 2 on page 56).
7. Check the lower limit position of the Saw Blade.
Although it was adjusted before shipment, carefully check the height of the saw blade.
Confi rm that the saw blade can be lowered 9 mm to 11 mm below the table insert. For
details, see the section on "Checking the saw blade lower limit position".
8. Check the Power Receptacle.
To prevent overheating, accidental stopping or intermittent operation, confi rm that the
power cord plug fi ts properly in the electrical receptacle and does not fall out after it is
inserted. Repair or replace the receptacle if it is faulty.
9. Confi rm the tool's power cord is not damaged.
Repair or replace the power cord if an inspection indicates that it is damaged.
61
English
Lower guard
Fig. 6