Preparation Before Operation - Hitachi C 12LSH Handling Instructions Manual

English

PREPARATION BEFORE OPERATION

Make the following preparations before operating
the power tool:
1. Installation
Attach the power tool to a level, horizontal
work bench in accordance with Fig. 3.
Select 8 mm diameter bolts suitable in
length for the thickness of the work bench.
Bolt length should be at least 40 mm plus
the thickness of the work bench.
For example, use 65 mm or larger bolts for
a 25 mm thick work bench.
The holder attached to the rear of the base
helps stabilize the power tool.
Holder adjustment (Fig. 4):
Loosen the 6 mm bolt with the 10 mm box
wrench.
Adjust the holder until its bottom surface
contacts the work bench surface.
After adjustment, fi rmly tighten the 6 mm
bolt.
2. Releasing the locking pin (Fig. 5)
When the power tool is prepared for
shipping, its main parts are secured by a
locking pin.
Move the handle slightly so that the
locking pin can be disengaged.
NOTE
Lowering the handle slightly will enable
you to disengage the locking pin more
easily and safely.
The lock position of the locking pin is for
carrying and storage only.
3. Installing the dust bag, holder, stopper
and vises
(The holder and stopper are optional
accessories.)
Attach the dust bag and vise assembly
as indicated in Fig. 1 on page 56 and
Fig. 2 on page 56.
9 mm
3 holes
244 mm 281 mm
Base
Work bench
Move
Adjust the holder until its bottom surface
contacts the work bench surface.
Locking pin
Pull
60
8mm bolt
8 mm nut
Fig. 3
6 mm Bolt
Holder
Fig. 4
Handle
Fig. 5