Hitachi C 12LSH Handling Instructions Manual page 79

Cutting method of crown molding
without tilting the saw blade
(1) Crown molding Stopper (L) and
(R) (optional accessories) allow
easier cuts of crown molding
without tilting the saw blade. Install
them in the base both-sides side
to be shown in Fig. 49-a. After
inserting Tighten the 6mm knob
bolts to secure the crown molding
Stoppers.
[Optional accessories used]
• Crown molding Vise Ass'y (Include
Crown molding Stopper (L))
• Crown molding Stopper (L)
• Crown molding Stopper (R)
(2) The crown molding vise (B) (Optional
accessory) can be mounted on either the
left fence (Fence (B)) or the right fence
(Fence (A)). It can unite with the slope
of the crown molding and vice can be
pressed down.
Then turn the upper knob, as necessary,
to securely attach the crown molding
in position. To raise or lower the vise
assembly, fi rst loosen the 6 mm knob bolt.
After adjusting the height, fi rmly tighten
the 6 mm wing bolt; then turn the upper
knob, as necessary, to securely attach the
crown molding in position. (See Fig. 49-b)
WARNING
Always fi rmly clamp or vise to secure the crown molding to the fence; otherwise
the crown molding might be thrust from the table and cause bodily harm.
Do not bevel cutting. The main body or saw blade may contact the sub fence,
resulting in an injury.
CAUTION
Always confi rm that the motor head (see Fig. 1 on page 56) does not contact the
crown molding vise ass'y when it is lowered for cutting. If there is any danger that
it may do so, loosen the 6mm knob bolt and move the crown molding vise ass'y to
a position where it will not contact the saw blade.
Crown molding vise ass'y
(optional accessories)
6mm knob bolt
6mm wing bolt
Crown molding vise ass'y
(Optional accessories)
6mm knob bolt
Fence
6mm wing bolt Crown molding
79
Crown molding
stopper (R)
6mm
(optional accessories)
knob
bolt
Crown molding stopper (L)
(Optional accessories)
Fig. 49-a
Knob
Crown molding stopper (L)
Crown molding stopper (R)
(Optional accessories)
Fig. 49-b
English