Hitachi C 12LSH Handling Instructions Manual page 78

English
(3) Setting to cut crown moldings at positions 1
and 4 in Fig. 40 on page 76 (see Fig. 45; tilt
the head to the right):
1 Turn the turntable to the right and set the
Miter Angle as follows:
* For 45° type crown moldings:
35.3° ( mark)
* For 38° type crown moldings:
31.6° ( mark)
2 Tilt the head to the right and set the Bevel
Angle as follows:
* For 45° type crown moldings:
30° ( mark)
* For 38° type crown moldings:
33.9° ( mark)
3 Position the crown molding so that the
upper surface (B in Fig. 39 on page 76)
contacts the fence as indicated Fig. 47.
(4) Setting to cut crown moldings at positions 2
and 4 in Fig. 40 on page 76 (see Fig. 46; tilt
the head to the right):
1 Turn the turntable to the left and set the
Miter Angle as follows:
* For 45° type crown moldings:
35.3° ( mark)
* For 38° type crown moldings:
31.6° ( mark)
2 Tilt the head to the right and set the Bevel Angle
as follows:
* For 45° type crown moldings:
30° ( mark)
* For 38° type crown moldings:
33.9° ( mark)
3 Position the crown molding so that the lower
surface (A in Fig. 39 on page 76) contacts the
fence as in Fig. 48.
Bevel angle scale
Miter angle scale
Turntable
Bevel angle scale
Fence (B)
Base
Fence
Ⓑ
Fence
Ⓐ
78
Head
4
1
Base
Fig. 45
Head
2
3
Miter angle scale
Turntable
Fig. 46
Table on base
Fig. 47
Table on base
Fig. 48
Fence (A)
Ⓐ
Ⓑ