Hitachi C 12LSH Handling Instructions Manual page 64

English
(1) Lower the motor head, and turn the 8 mm depth adjustment bolt and make adjustments so
that there can be a clearance of 2 mm to 3 mm between the lower limit position of the motor
head and the top of the workpiece at the saw blade's lower limit position where the head of
the 8 mm depth adjustment bolt contacts the hinge.
5. Confi rmation for use of sub fence (A)
WARNING
In the case of right bevel cutting, turn the sub fence (A) clockwise. Unless it is
turned clockwise, the main body or saw blade may contact the sub fence (A),
resulting in an injury.
This power tool is equipped with a
sub fence (A).
In the case of direct angle cutting
and left bevel angle cutting, use the
sub fence (A). Then, you can realize
stable cutting of the material with a
wide back face.
In the case of right bevel cutting,
raise the sub fence (A) up as
illustrated in Fig. 10 and then turn it clockwise.
6. Confi rmation for use of sub fence (B)
WARNING
In the case of left bevel cutting, turn the sub fence (B) counterclockwise. Unless it
is turned counterclockwise, the main body or saw blade may contact the sub fence
(B), resulting in an injury.
This power tool is equipped with a sub
fence (B). In the case of direct angle
cutting and right bevel angle cutting,
use the sub fence. Then, you can
realize stable cutting of the material
with a wide back face. In the case of
left bavel cutting, raise the sub fence
up as illustrated in Fig. 11 and then
turn it counterclockwise.
7. Oblique angle
Before the power tool is shipped from
the factory, it is adjusted for 0°, right
angle, left 45° bevel cutting angle and
right 45° bevel cutting angle with the 8
mm set screw, 8 mm bolt (A) and
8 mm bolt (B).
Left bevel angle cutting
Direct angle cutting
Fence (A)
Turn
Left bevel
angle cutting
Sub fence (B)
8 mm bolt (B)
(Stopper for right 45° bevel angle)
64
Turn Right bevel angle
cutting
Sub fence (A)
Fig. 10
Right bevel angle cutting
Direct angle cutting
Fence (B)
Fig. 11
Indicator
(For left bevel scale)
8 mm set screw
(Stopper for 0° not shown)
Fig. 12-a