Hitachi C 12LSH Handling Instructions Manual page 66

English
11. Using an ink line
(1) Right angle cutting
Loosen the 6 mm knob bolt and
contact the tip of the guard with the
workpiece.
Aligning the ink line on the workpiece
with the groove of the guard, the
workpiece is cut on the ink line
(Fig. 15).
(2) Miter cutting and compound cutting
(Miter cutting + bevel cutting)
Upon lowering the motor section, the
lower guard is raised and the saw
blade appears.
Align the ink line with the saw blade
(Fig. 16).
CAUTION
In some arrangements when the
turntable is rotated, the guard projects from the fence surface. Loosen the 6 mm
knob bolt and push the guard to the retracted position. Never lift the lower guard
while the saw blade is rotating. When cutting at an angle to the right or more,
please slide the guard to the rear. The guard and sub-fence (A) and sub-fence (B)
will not only make contact and adversely aff ect cutting accuracy, this could also
result in damage to the guard.
12. Position adjustment of laser line
WARNING
Make sure before plugging the power plug into the receptacle that the main body
○
and the laser marker are turned off .
Exercise utmost caution in handling a switch trigger for the position adjustment of
○
the laser line, as the power plug is plugged into the receptacle during operation.
If the switch trigger is pulled inadvertently, the saw blade can rotate and result in
unexpected accidents.
Do not remove the laser marker to be used for other purposes.
○
Saw blade groove
Marking (pre-marked)
Move the
guard
backward
Sub fence (B)
66
6 mm knob bolt
Guard
Workpiece
Fig. 15
Lower guard
6 mm knob bolt
Marking
(pre-marked)
Fig. 16