Hitachi C 12LSH Handling Instructions Manual page 65

When changing the adjustment, change
the height of the 8 mm set screw, 8 mm bolt
(A), or 8 mm bolt (B) by turning them.
When changing the bevel angle to the right
45°, pull the set pin (A) on the direction
shown in Fig. 12-b and incline the motor
head to the right.
When adjusting the motor head to 0°,
always return the set pin (A) to its initial
position as shown in Fig. 12-b.
8. Securing the workpiece
WARNING
Always clamp or vise to secure the workpiece to the fence; otherwise the
workpiece might be thrust from the table and cause bodily harm.
9. Installing the holders (Optional accessory)
The holders help keep longer workpieces stable and in place during the cutting operation.
(1) As indicated in Fig. 13, use a steel
square for aligning the upper edge of
the holders with the base surface.
Loosen the 6 mm wing nut. Turn a
height adjustment bolt 6 mm, and
adjust the height of the holder.
(2) After adjustment, fi rmly tighten the
6 mm wing nut and fasten the holder
with the 6 mm knob bolt (optional
accessory). If the length of Height
Adjustment Bolt 6 mm is insuffi cient,
spread a thin plate beneath. Make sure
the end of Height Adjustment Bolt 6 mm
does not protrude from the holder.
10. Stopper for precision cutting (Stopper
and holder are optional accessory)
The stopper facilitates continuous
precision cutting in lengths of 285 mm
to 450 mm.
To install the stopper, attach it to the
holder with the 6 mm wing bolt as
shown in Fig. 14.
Indicator
(For right
bevel scale)
8 mm bolt (A)
(Stopper for left 45° bevel angle)
Holder
(Optional
accessory)
Steel square
6 mm wing nut
(Optional accessory)
Workpiece Stopper (Optional accessory)
6 mm knob bolt
(Optional accessory)
65
English
Set pin (A)
Pull
Fig. 12-b
6 mm knob bolt
(Optional accessory)
Base surface
Height adjustment bolt 6 mm
(Optional accessory)
Fig. 13
Holder (Optional accessory)
Move
Fig. 14