Toshiba Tecra M1 Maintenance Manual page 335

4 Replacement Procedure
5. Fixing PCBs and bezel with screws
1) Tighten the left side with the screws in order shown in the figure below.
2) Tighten the right side with the screws in order shown in the figure below.
NOTE: 1) Tighten the screws in order. Make sure there is no floating of screw.
2)
3)
(5)
(6)
Figure 4-60 Replacing TOSHIBA fluorescent lamp (XGA) (10)
4-98
The screw tightening torque shall be 0.147mN m (1.5kgf cm).
Use a Philips screwdriver with type 0 bit.
Tighten the eight screws.
(7)
(8)
4.25 Fluorescent Lamp
(1)
(2)
TECRA M1 Maintenance Manual (960-436)
(3)
(4)