Ieee1394 Test - Toshiba Tecra M1 Maintenance Manual

3.20 IEEE1394 Test Program
3.20 IEEE1394 Test Program
This section describes how to perform the IEEE1394 test with the test program.
Toshiba MS-DOS is required to run the DIAGNOSTICS TEST PROGRAM. To start the
DIAGNOSTIC TEST PROGRAM, follow these steps:
(a) Insert the Diagnostics disk in the floppy disk drive and turn on the computer.
(The Diagnostics Disk contains the MS-DOS boot files.)
The following menu will appear:
***********************************************************************
* ------------------------------------------------------------
*
* ------------------------------------------------------------
*
* ============
*
* 1
* 2
* 3
*
***********************************************************************
Select [1-3]?
(b) To execute the TEST, select the test number you want to execute and press Enter.
TECRA M1 Maintenance Manual (960-436)
IEEE1394 [TSB!"LV28] test menu ( For Repair ) VX.XX
Select test No. and [Enter]
: ... Ieee1384 test
: ... Responder tool
: ... ID Check
3 Tests and Diagnostics
============
3-51
*
*
*
*
*
*
*
*
*
*