Toshiba Tecra M1 Maintenance Manual page 278

4 Replacement Procedures
Installing the Wireless LAN Card
To install the wireless LAN card, make sure that the computer is in boot mode and powered off,
follow the steps below and refer to figures 4-23 and 4-24.
CAUTION: Be sure to switch the computer off before removing the wireless LAN card.
Otherwise, the computer or the wireless LAN card may be damaged.
1. Insert the wireless LAN card into the connector at an angle of 45 degrees.
2. Gently push the wireless LAN card down until the latches on both sides engage the wireless
LAN card to hold it in place.
3. Connect the wireless LAN antenna cables (black and white) to the connectors on the
wireless LAN card.
4. (For a/b combo models only)
Install the wireless LAN card cover and secure it with the following screw.
M2 4 OSG screw
CAUTION: There are two MAC address barcode labels in the package
containing the new wireless LAN card. Apply one label next to the wireless LAN
socket and one on the box the computer was shipped in. Before you apply the new
labels, remove the old ones from the computer and the box. The computer may
have MAC address barcode labels for both wired and wireless LANs. Be sure to
replace the correct label.
4-46
4.13 Wireless LAN Card
1
TECRA M1 Maintenance Manual (960-436)