Toshiba Tecra M1 Maintenance Manual page 220

3 Tests and Diagnostics
When the Printer Port Mode (see settings below) is set to ECP, the DMA channel
can also be set to 1, 2 or 3. The default is 3.
LPT setting
LPT 1
LPT 2
LPT 3
Not Used
When you select one of the above options, except for Not Used, a subwindow
similar to the one below appears to let you set the DMA. The options for this setting
are Channel 1and Channel 3 (Default).
For most printers, the port should be set to ECP. With some other parallel devices,
the setting should be Std. Bi-Direct.
10. Drives I/O
This option displays the address and interrupt level for hard disk drive, CD/DVD-ROM
drive and PC card. It is for information only and cannot be changed.
(a) Built-in HDD
Primary IDE (1F0H/IRQ14) The Built-in HDD is ready for use.
No Drive
(b) Select Bay
This option is displayed only when the hard disk drive or optical disk drive is
installed to the select bay. Secondary IDE (170H/IRQ15) Computer Selectable
Bay HDD.
(c) PC Card
When an ATA card is installed in IN13h, the sub window below is displayed.
Built-in HDD
ATA Card
3-92
Interrupt level
7
5
7
Disables the port
OPTIONS
DMA = Channel 3 (Default)
DRIVES I/O
= Primary IDE (1F0H/IRQ14)
= Others (190H/IRQ)
I/O address DMA channel
378H 3 (Parallel port default)
278H 3
3BCH 3
The Built-in HDD is not installed.
TECRA M1 Maintenance Manual (960-436)
3.29 SETUP