Mw 800 Keyboard - Motorola MW 800 Series Vehicle Installation Manual

Step 5. Place the mount assembly with the CPU Box mount (if desired) in the vehicle and
use it for marking the location of the base plate or the hump plate on the vehicle
transmission hump. If no hump exists, place the pedestal or SDI tunnel plate between
the driver and the passenger seats for marking the location.
Step 6. At the proper location, drill four 1/4" holes into the transmission hump or the hump
plate in order to achieve optimal functionality and use of the MW 800.
.
Step 7. Attach the pedestal to the desired anchor point on the transmission hump or on the
hump plate, using studs and nuts, screws and nuts or self-tapping screws, as required.
Steps 8 and 9 are optional for adjusting the tilt tension.
Step 8. Remove the two end caps.
Step 9. Fold down tension should be adjusted by tightening the two 5/16" nuts at the edges
of the folding mechanism. This can also be done when the MW 800 display is
installed on the mount assembly.
Step 10. Attach the display to the mount and route the Display Signal Cable down the
pedestal. Ensure that the Display Signal Cable has enough slack to move when the
display is tilted down.
Step 11. Rotate the keyboard left and right to determine the range of swivel. Some hump
plates are attached to the anchor points of the seats. These hump plates allow
adjustment front to back, thus allowing for fine-tuning of the installation.
Step 12. Fold the display up and down to determine the available range for the given vehicle
and application. When mounting the keyboard, care must be exercised to ensure
sufficient space for proper installation of the device. This will restrict the amount of
tilt/swivel available.

MW 800 Keyboard

The keyboard tray is attached to the MW 800 mount. The keyboard tray may be removed if
desired and can be tilted or swiveled.
If required, the keyboard can be placed elsewhere in the vehicle to allow for use of other
installed equipment. Please ensure that all safety guidelines and air-bag deployment
requirements are met.
The keyboard is provided with a quick release holder to allow operation of the keyboard
when out of the holder. Care must be used to ensure ample space for extracting and
reinserting the keyboard into the holder. Ensure that the cable is routed in a manner that
allows the operator to remove the keyboard from the mounting tray and operate the keyboard
in their lap.
Be careful not to drill into the transmission. Some commercially
!
available hump plates, such as the SDI 7200 system, may
have the hole pattern already pre-drilled.
Caution
Installation 13