MW 800 CPU Box
The MW 800 CPU box should be mounted so that the cables from the keyboard(s),
display(s), power system and peripherals can be attached. The limiting factor is the 17 feet
length of the display signal cable. When attached to the display, this cable is routed down
through the pedestal to the CPU box. Use plastic cable ties to secure the cables to the cable
tie bracket.
Important Note:
Figure 11
CPU Box - Cable Tie Bracket (F5206 only)
Radio modems can be installed inside the CPU box via the PC card slot. The antenna cable
can be routed to an external antenna through one of the two openings located on the back side
of the PC card door (see Figure 12).
Figure 12
CPU Box - Antenna Cable Route of Radio Modem Installed in PC Card Slot
Use the supplied rubber plugs to cover the unused receptacles.
Do not remove the seals from the PC card door. The seals press
against the antenna cable when the door is closed.
Note
Seal
Antenna Cable
Cable Tie Bracket
Radio Modem
Openings in PC Card Door
Installation
15
Seal