Tv Output Signal - Toshiba TE2300 User Manual

TV output signal

Refer also to your Personal Conferencing Kit's documentation.
Problem
Display on TV is poor
No display
USB
Refer also to your USB device's documentation.
Problem
USB device does not
work
TOSHIBA TE2300
Check Windows Device Manager. Make sure the
sound function is enabled and that settings for
I/O address, Interrupt level and DMA are correct
for your software and do not conflict with other
hardware devices that you may have connected
to the computer.
If problems persist, contact your dealer.
Procedure
Make sure the TV type is correct for your area:
NTSC (US, JAPAN), PAL (Europe).
Try adjusting the contrast and brightness
controls on the external monitor.
Press hotkeys Fn + F5 to change the display.
Refer to Chapter 5, The Keyboard.
If you turn the computer off in Resume mode
while the display is on TV, the computer will
select either the internal LCD or an external
computer CRT as the display device.
If problems persist, contact your dealer.
Procedure
Check for a firm cable connection between the
USB ports on the computer and the USB device.
Make sure the USB device drivers are properly
installed. Refer to your Windows documentation
for information on checking the drivers.
If you are using an operating system that does
not support USB, you can still use a USB mouse
and/or USB keyboard. If these devices do not
work, make sure the USB KB/Mouse Legacy
Emulation item in HW Setup is set to Enabled.
If problems persist, contact your dealer.
Troubleshooting
9-15