Parallel Printer - Toshiba TE2300 User Manual

Security lock slot
Audio line-in, line-out jacks
Universal Serial Bus (two) ports
i.LINK (IEEE 1394) port (This port is not supported by the computer.)
DVI port (This port is not supported by the computer.)
1. When a Port Replicator is connected to the computer, remove all
cables connected to the computer.
2. The TE2300 does not support the DVI and i.LINK ports on the
Advanced Port Replicator II.

Parallel printer

You can connect any standard Centronics-compatible parallel printer to
your computer. All you need is an IBM PC™ parallel printer cable. Your
dealer can supply one or you can purchase one at most computer stores.
The cable's connectors are designed so that it is impossible for you to
connect them incorrectly. You can also connect a parallel printer to an
optional Advanced Port Replicator. To connect a printer, follow these
steps:
1. Turn off the computer.
2. Insert one end of the cable into the computer's parallel port.
3. Tighten the screws that fasten the cable connector to the
4. Insert the other end of the cable into the printer's parallel connector.
5. Fasten the connector to the printer with the clips on the parallel port.
6. Turn on the printer.
7. Turn on the computer.
8. Start the Hardware Setup program. Refer to Chapter 7 HW Setup
9. Select the Parallel/Printer tab from the TOSHIBA HW Setup
10. Set the Parallel Port Mode and press OK.
11. Choose Reboot for the change to take effect.
12. Select the printer in Windows Add Print Wizard. To access the Add
TOSHIBA TE2300
computer's parallel port.
and Passwords.
window.
Print Wizard utility, click Start, point to Settings, click Printers
and double click the Add Printer icon.
Optional Devices
8-9