Copy The Switch Configuration File From A Usb Drive To A Switch - Dell EMC DP5300 Field Replacement Manual

Copy the switch configuration file from a USB drive to a switch

Note
Both rows of QSFP+ ports require that you install the 40GbE optics with the
l
tabs facing up.
When you cable the ports, be sure not to interfere with the airflow from the
l
small vent holes above and below the ports.
Once the switch is replaced, the configuration file for the switch must be copied from
a removable USB drive that is dedicated for this purpose.
CAUTION
Only use a USB drive that is dedicated to copying and loading the switch
configuration file to a system. Do not use any other USB drive, nor should you
copy any other files onto the dedicated USB drive. Doing so may cause serious
damage to the system.
The following tools are required to perform this procedure:
RJ45 to serial cable
l
USB to Serial adapter cable
l
Dedicated USB thumbdrive
l
Procedure
1. Locate the USB port on the front of the switch, right side immediately below
the stacking ID indicator is the USB Type-A connector.
2. Insert the USB thumb drive into the USB port.
Copy the switch configuration file from a USB drive to a switch
DELL EMC CONFIDENTIAL
Dell S4048-ON Switch FRUs
87