Install The Replacement Switch In The Cabinet; Remove Inner Rails - Dell EMC DP5300 Field Replacement Manual

Install the replacement switch in the cabinet

Figure 25 Remove inner rails
1. Front standoff locking tab
2. Switch
3. Rail locking tab
2. On each side of the replacement switch, align the inner rail over the shoulder
studs on the switch.
3. Slide the inner rail rearward until the rail locking tab latches behind the front
shoulder stud on the switch.
Procedure
1. At the rear of the cabinet, line up the inner rails with the previously mounted
Ready-Rails. Slide the switch in until it is flush with the rail bracket (item 2
below). About 3 inches before you fully insert your system, the rail locking
feature engages to keep the switch from inadvertently sliding out of the rack
and falling.
2. Tighten the two mounting screws to secure the switch to the rail brackets.
DELL EMC CONFIDENTIAL
Install the replacement switch in the cabinet
Dell S4048-ON Switch FRUs
85