Install The System In The Cabinet - Dell EMC DP4400 Hardware Installation Manual

Procedure
1. Align the screws with the designated U spaces on the front and rear rack flanges.
2. Insert and tighten the two screws using the Phillips #2 screwdriver.

Install the system in the cabinet

About this task
Procedure
1. At front of the cabinet, pull the inner slide rails out of the cabinet until they lock into place.
Ensure that the screw holes on the tab of the system retention bracket are seated on the
designated U spaces.
Figure 3 Installing screws
WARNING The system is heavy and should be installed in a cabinet by two people. To avoid
personal injury and/or damage to the equipment, do not attempt to install the system in a
cabinet without a mechanical lift and/or help from another person.
Dell EMC Integrated Data Protection Appliance DP4400 2.4 Hardware Installation Guide
7