Table of Contents
Advertisement
Memory expansion
Refer also to Chapter 8, Optional Devices, for information on installing
memory modules.
Problem
Beep sounds. (If
memory is in slot A, a
long beep (1 second)
followed by two short
beeps (0.5 second
each). If in slot B, a
long beep followed by
four short beeps. If
both in slot A and slot
B, a long beep
followed by two short
beeps and after a
pause (1 second) a
long beep followed by
four short beeps.)
Standby/Hibernation
Problem
The system will not
enter
Standby/Hibernation
Portégé M200
Procedure
Make sure the memory module installed in the
expansion slot is compatible with the computer.
If an incompatible module has been installed,
follow the steps below.
1. Turn off the power.
2. Disconnect the AC adaptor and all peripheral
devices.
3. Remove the battery pack.
4. Remove the memory module.
5. Install the memory module compatible with
the computer.
6. Install the battery pack and/or connect the
AC adaptor.
7. Turn on the power.
Procedure
Is Windows Media™ Player open? The system
might not enter Standby/Hibernation, if Windows
Media Player is either playing a selection or
finished playing a selection. Close Windows
Media Player before you select
Standby/Hibernation.
If problems persist, contact your dealer.
Troubleshooting
9 14
Advertisement
Table of Contents
