Table of Contents
Advertisement
Creation of a boot disk
In TOSHIBA SD Memory Boot Utility, a boot disk can be created with SD
memory card. Refer to the Utilities section of Chapter 1 for details.
Memory expansion
This computer is equipped with two memory module sockets; Slot A and
Slot B on the underside of the computer. You can increase the amount of
RAM to 2048MB by installing an additional memory or replacing default
memories with additional memories.
Observe the following instructions according to the model you purchased.
Install an additional memory module to Slot B for the computer with
I
vacant Slot B.
You can increase the memory amount by replacing the memory
I
module in Slot A and/or B with a memory module of larger memory
amount when both Slot A and Slot B are occupied. However,
replacing of memory module in Slot B is recommended because it is
easier to replace the memory module in Slot B than A.
It is strongly recommended to leave the replacing of memory module
I
preinstalled in Slot A to TOSHIBA dealer because the installing or
replacing of memory module in Slot A needs skill.
Place a mat beneath the computer to prevent making a scratch on the lid
when replacing the memory module. Avoid the mat that generates static
electricity.
Use only memory modules approved by TOSHIBA.
Do not try to install or remove a memory module under the following
conditions. You can damage the computer and the module. Also, data will
be lost.
The computer is turned on.
I
The computer was shut down using the Standby mode or Hibernation
I
mode.
Wake up on LAN is enabled.
I
Portégé M200
Optional Devices
8 6
Advertisement
Table of Contents
