Table of Contents
Advertisement
User's Manual
Memory expansion
This computer is equipped with two memory module sockets; Slot A beneath the
keyboard and Slot B in the backside of the computer. You can increase the amount
of RAM to 1024MB by installing an additional memory or replacing default memo-
ries with additional memories.
NOTE: Observe the following instructions according to the model you
purchased.
•
Install an additional memory module to Slot B for the computer with
vacant Slot B.
•
You can increase the memory amount by replacing the memory
module in Slot A and/or B with a memory module of larger memory
amount when both Slot A and Slot B are occupied. However, replac-
ing of memory module in Slot B is recommended because it is easier to
replace the memory module in Slot B than A.
• It is strongly recommended to leave the replacing of memory module
preinstalled in Slot A to TOSHIBA dealer because the installing or
replacing of memory module in Slot A needs skill.
CAUTION: Use only memory modules approved by TOSHIBA.
CAUTION: Do not try to install or remove a memory module under the
following conditions. You can damage the computer and the module.
Also, data will be lost.
1.
The computer is turned on.
2.
The computer was shut down using the Standby mode or Hibernation
mode.
3.
Wake-up on LAN is enabled.
CAUTION: Do not change the memory module in Slot B while the
computer is in Tablet PC mode.
CAUTION: Be sure to install memory module to Slot A. The computer
does not boot when Slot A is vacant.
8-10
Advertisement
Table of Contents
