Table of Contents
Advertisement
Optional Devices
If you install a memory module that is not compatible with the computer,
beep will sound when you turn on the power. If the module is installed in
slot A, there will be a long beep (1 second) followed by two short beeps
(0.5 second each). If the memory module is in slot B, there will be a long
beep followed by four short beeps. If the both memory modules in slot A
and slot B are incompatible, there will be a long beep followed by two
short beeps and after a pause (1 second) a long beep followed by four
short beeps. In this case, shut down the power and remove the
incompatible module(s).
Be sure to install memory module to Slot A. The computer does not boot
when Slot A is vacant.
Use a 1 bit, Phillips screwdriver to remove and fasten screws. Use of an
incorrect screwdriver can damage the screw heads.
Installing memory module
Follow the steps below to install a memory module.
1. Save data, shutdown Windows and turn the power off.
2. Remove the AC adaptor cable and other cables from the computer.
3. Close the display panel and turn the computer over. Remove the
Battery Pack.
4. Remove a screw on the cover of the memory module slot.
Be careful that the removed screw will not be fallen into the memory
module slot.
Removing the memory module cover
Portégé M200
8 7
Advertisement
Table of Contents
