Table of Contents
Advertisement
Warning
1. Never allow caustic electrolyte fluid leaked from a battery pack to
contact your eyes, skin or clothing. If caustic electrolyte fluid should
contact your eyes, immediately wash your eyes with large amounts of
running water and seek medical attention, to help prevent eye
damage. If electrolyte fluid should contact your skin immediately wash
it under running water to prevent rash. If it contacts your clothes,
promptly remove them to prevent the fluid from contacting your skin
or eyes.
2. Immediately turn off the power, disconnect the AC adaptor and
remove the battery if any of the following events are observed in the
battery pack: offensive or unusual odour, excessive heat,
discoloration or deformation. Never use the computer again until it has
been checked by a TOSHIBA service provider. It might generate
smoke or fire, or the battery pack might rupture.
3. Make sure the battery is securely installed in the computer before
attempting to charge the battery pack. Improper installation could
generate smoke or fire, or cause the battery pack to rupture.
4. Keep the battery pack out of reach of infants and children. It can
cause injury.
Caution
1. Never continue to use a battery pack after its recharging capacity has
become impaired, or after the display of a warning message indicating
that the battery pack's power is exhausted. Continued use of an
exhausted or impaired battery pack could cause the loss of data.
2. Never dispose of battery packs with normal trash. Bring them to your
TOSHIBA dealer or to another recycling centre to save resources and
prevent environmental damage. Cover the terminals with electrical
tape to prevent short circuits, which could cause the battery pack to
ignite or rupture.
3. Use only battery packs recommended by TOSHIBA as replacements.
4. Always make sure the battery pack is installed correctly and securely.
Otherwise, a battery pack could fall out and possibly cause injury.
5. Charge the battery pack only in an ambient temperature between 5
and 35 degrees Celsius. Otherwise, the electrolyte solution might leak,
battery pack performance might deteriorate and the battery life might
be shortened.
6. Be sure to monitor the remaining battery power. If the battery pack
and real time clock battery discharge completely, Standby and
Suspend will not function and data in memory will be lost. Also, the
computer might register an incorrect time and date. In this case,
connect the AC adaptor to recharge the batteries.
7. Never install or remove the battery pack without first turning off the
power and disconnecting the AC adaptor. Never remove the battery
pack while the computer is in Suspend or Standby mode. Data will be
lost.
Portégé M200
Power and Power Up Modes
6 6
Advertisement
Table of Contents
