Table of Contents
Advertisement
Portégé M200
Internal Modem Guide
This appendix describes how to install and the remove the internal
modem.
Do not remove the base cover except to remove or install the internal
modem or to check the PTT label.
Do not disassemble the computer beyond the steps described in this
instruction or touch any components not specifically described.
Always remove the Battery Pack and disconnect the AC Adaptor before
removing the base cover.
Be careful not to drop any screws or other foreign matter into the
computer. Metal or other foreign matter can damage the computer.
Installing the internal modem
The internal modem is preinstalled. The following is for information only.
To install the modem board, follow the steps below.
1. Save your data, quit Windows and turn off the power.
2. Disconnect the AC Adaptor and any other peripheral devices.
3. Close the display panel and turn the computer over. Remove the
Battery Pack.
4. Remove one screw under the battery pack slot.
5. Remove the memory slot cover and remove the fan cable.
6. Remove the cover of a hard disk drive slot.
7. Remove nine screws of the base cover of the computer, and remove
the base cover.
8. Connect the modem cable to the modem board.
9. Secure the modem board with the two screws.
10. Seat the base cover and secure it with nine screws.
11. Seat the cover of a hard disk drive slot.
User's Manual
Portégé M200
Appendix G
Internal Modem Guide
G-1
G 1
Advertisement
Table of Contents
