Functions And Settings; Operation; Maintenance; Maintenance And Cleaning The Unit - ProLights MINIECLIPSE Series User Manual

10

- 3 - FUNCTIONS AND SETTINGS

3.1 OPERATION

To turn on the MINIECLIPSE connect the supplied main cable to a socket (100-240 VAC-50/60 Hz). Then the
unit is ready for operation. You can also adjust the dimmer and zoom using the knobs.
To switch off, disconnect the mains plug from the socket. For a more convenient operation it is recom-
mended to connect the unit to a socket which can be switched on and off via a light switch.
NOTE - To operate the projector MINIECLIPSETR you need a system track. The track system must be in-
stalled and maintained by a suitably qualified person in compliance with latest construction and relevant
legislation. It is the responsibility of the installer to ensure the electrical, mechanical and thermal com-
patibility of the track system and the fittings. The connection to the main network of electric distribution
must be carried out by a qualified electrical installer.
ATTENTION - Mains voltage must be switched off before mounting; maintenance; insert and replace
Adaptors; spots and luminaires.

- 4 - MAINTENANCE

4.1 MAINTENANCE AND CLEANING THE UNIT

• Make sure the area below the installation place is free from unwanted persons during setup.
• Switch off the unit, unplug the main cable and wait until the unit has cooled down.
• All screws used for installing the device and any of its parts should be tightly fastened and should not
be corroded.
• Housings, fixations and installation spots (ceiling, trusses, suspensions) should be totally free from any
deformation.
• The main cables must be in impeccable condition and should be replaced immediately even when a
small problem is detected.
• It is recommended to clean the front at regular intervals, from impurities caused by dust, smoke, or
other particles to ensure that the light is radiated at maximum brightness. For cleaning, disconnect the
main plug from the socket. Use a soft, clean cloth moistened with a mild detergent. Then carefully wipe
the part dry. For cleaning other housing parts use only a soft, clean cloth. Never use a liquid, it might
penetrate the unit and cause damage to it.

4.2 TROUBLESHOOTING

Problems
Fixture does not light up
General low light intensity
Fixture does not power up
Contact an authorized service center in case of technical problems or not reported in the table can not be
resolved by the procedure given in the table.
MINIECLIPSE - MINIECLIPSETR
Possible causes
No mains supply
•
Dimmer fader set to 0
•
Faulty LED
•
Dirty lens assembly
•
Misaligned lens assembly
•
No power
•
Loose or damaged power cord
•
Checks and remedies
Check the power supply voltage
•
Increase the value of the dimmer channels
•
Replace the LED board
•
Clean the fixture regularly
•
Install lens assembly properly
•
Check for power on power outlet
•
Check power cord
•