Installation; Mounting - ProLights MINIECLIPSE Series User Manual

Mini led ellipsoidal, reflector housing, optics not included/not included

Table of Contents

Available languages

- 2 - INSTALLATION

MINIECLIPSE/MINIECLIPSETR is designed for applications in exhibition areas, commercial spaces, muse-

ums, restaurant, churches, and any other installation where size is an important factor. For fixing, stable

mounting clips are required. The mounting place must be of sufficient stability and be able to support a

weight of 10 times of the unit's weight.

When carrying out any installation, always comply scrupulously with all the regulations (particularly re-

garding safety) currently in force in the country in which the fixture's being used.

• Install the projector at a suitable location.

• Always additionally secure the projector with the safety rope from falling down. For this purpose, fas-

ten the safety rope at a suitable position so that the maximum fall of the projector will be 20 cm.

• Adjust the projector and use the knobs.

NOTE - For the installation of the MINIECLIPSETR make sure that the ridge of the adaptor is in with the

groove of the track. Turn knobs 90° to connect the adaptor to the circuit. Please see the below instructions.

MINIECLIPSE - MINIECLIPSETR

Fig.4

Table of Contents

Table of Contents