Fault Codes - Optimum THERMOCOOK PRO M User Manual

FAULT CODES:

Code
E01 "E01" on LCD is flashing.
"E02" on LCD is flashing.
E02
The bowl wasn't installed.
"E03" on LCD is flashing.
E03
"E04" on LCD is flashing.
E04
LCD is flashing.
-
CLEANING:
1. Before you clean the appliance, switch the appliance off and remove the plug from the socket.
2. While cleaning, don't immerse the bowl in water.
3. After the bowl cool down, remove the blade from the bowl. Clean the inside and outside of the
bowl. Always keep the contact pins at the bottom of the bowl clean and dry. Only Wipe the contact
pins with a wet cloth!
4. Unscrew the screw ring and remove all parts of the attachment. Remove the blade assy and place
the bowl only on the upper rack of the dishwasher
5. Never use pointed or sharp objects for cleaning as this may damage functional parts or affect the
safety of the appliance.
6. The blade is very sharp! Handle it with care!
7. Wash all parts in hot soapy water. Clean them immediately after use. Rinse them with clear hot
water and dry them immediately. Do not immerse blade assy.
8. We advise you to lubricate the blade with some vegetable oil.
9. Only wipe the main appliance with a damp soft cloth!
10. If the bowl and blade is hard to clean. You may add some hot soapy water in the bowl and run the
appliance at speed 1 for few seconds.
Status
Something goes wrong with the appliance. It
must be sent to the approved service centre for
repairing.
Install the bowl according to the operating
instruction.
The bowl cover wasn't installed. Install it
according to the operating instruction.
The temperature of appliance is too hot. let it cool
down 30 minutes to 2 hours, and then reboot it.
It must be sent to the approved service centre
for repairing if the previous cooperation doesn't
work.
Press"Start/Stop" button longer than 3 seconds to
recover it.
14
Solution