Section 3: Programming The Igsmv; General Information; Using The Alarmnet Direct Website; Using A 7720P Programming Tool - Honeywell AlarmNet IGSMV Installation And Setup Manual

                                                

General Information

The IGSMV is designed to deliver alarms via the Internet to an AlarmNet central station or
via the AlarmNet-G network, using GSM (Global System for Mobile) technology when the
Internet is not available.
The IGSMV uses 256 bit AES (Rijndael) encryption which is required for certain government
installations.
The IGSMV module requires an AlarmNet–I account. For new installations, please obtain the
account information from the central station prior to programming this module. For replacement
installations, the AlarmNet-i account is created automatically when the module is registered.
You can program a IGSMV by one of the following methods:
 Through the AlarmNet Direct website (required to enable Multi-Mode features)
 Through use of a 7720P Programming Tool
 Through a programming mode in the control panel, on panels that support this option
(e.g., VISTA-128BP and FBP)
UL

Using the AlarmNet Direct Website

To program the module via the website (if you are already signed up for this service), go to:
https://services.alarmnet.com/AlarmNetDirect/userlogin.aspx
If you are not signed up for this service, click on "Dealer Sign-Up.
Log in and follow the on-screen prompts.
Please have the following information available when programming the module:
1. Primary City ID (two-digit number)
2. Primary Central Station ID (two-digit hexadecimal number)
3. Primary Subscriber ID (four-digit number)
4. MAC ID and MAC CRC number (located on the outside of box and on label inside module)
After programming is complete, you must transfer the data to the module and the module
must be registered. Refer to Section 4: Registration, for further instructions.

Using a 7720P Programming Tool

Connect the 7720P Programming Tool as shown below. The IGSMV powers the 7720P
Programming Tool via the programming jack, and automatically senses the presence of the
7720P when it is plugged in.
Programming the IGSMV
Only ECP and Zone Trigger modes have been evaluated by UL.
S E C T I O N 3
3-1