Identification; Order Code Of Temposonics ® Rp5 - MTS Systems Temposonics R V POWERLINK Series Operation Manual

3. Identification

3.1 Order code of Temposonics
1 2 3 4 5
R P 5
a b c
a Sensor model
R P
5 Profi le
b Design
G Magnet slider backlash free (part no. 253 421),
suitable for internal linearization
L Block magnet L (part no. 403 448)
M U-magnet OD33 (part no. 251 416-2),
suitable for internal linearization
N Magnet slider longer ball-jointed arm (part no. 252 183),
suitable for internal linearization
O No position magnet
S Magnet slider joint at top (part no. 252 182),
suitable for internal linearization
V Magnet slider joint at front (part no. 252 184),
suitable for internal linearization
c Mechanical options
A Standard
V Fluorelastomer seals for the sensor electronics housing
d Stroke length
X X X X M 0025...6350 mm
Standard stroke length (mm)
25... 500 mm
500...2500 mm
2500...5000 mm
5000...6350 mm
.
X X X . X U 001.0...250.0 in.
Standard stroke length (in.)
1... 20 in.
20...100 in.
100...200 in.
200...250 in.
Non-standard stroke lengths are available;
must be encoded in 5 mm / 0.1 in. increments
e Number of magnets
X X 01...30 position(s) (1...30 magnet(s))
RP5
®
6 7 8 9 10 11 12
d e
Ordering steps
25 mm
50 mm
100 mm
250 mm
Ordering steps
1.0 in.
2.0 in.
4.0 in.
10.0 in.
13 14 15 16 17 18
D 5 6 1 U 3
f g
f Connection type
6 2 × M12 female connectors (5 pin),
D 5
1 × M8 male connector (4 pin)
g System
1 Standard
h Output
1 POWERLINK, position and velocity
U 3 0
(1...30 position(s))
1 POWERLINK, position and velocity,
U 3 1
internal linearization (1...30 position(s))
NOTICE
• For the RP5, the magnet selected in
the scope of delivery. For multi-position measurements with more
than one magnet, order the other magnets separately.
• The number of magnets is limited by the stroke length.
The minimum allowed distance between magnets (i.e. front face
of one to the front face of the next one) is 75 mm (3 in.).
• Use magnets of the same type for multi-position measurement,
e.g. 2 × U-magnet (part no. 251 416-2).
• If the option for internal linearization (U311) in
chosen, select a suitable magnet.
I 5 I
R-Series V POWERLINK
Temposonics
®
Operation Manual
19 20
1
h
b
"Design" is included in
h
"Output" is