Protocol KODIAK GPS Instruction Manual page 13

OPERATION: FLYING THE DRONE
STARTING THE ENGINE
After synchronizing the drone, move the throttle up and release to go into Idle
mode. The blades will rotate but the drone will not lift.
OR
After synchronizing the drone, pull the throttle and direction stick to the center at
the same time and release. The blades will rotate but the drone will not lift.
TAKE–OFF
1. From Idle mode, press the take off button. The remote will beep and the
drone will hover a few feet off the ground. Then gently advance the throttle to
a desired height and release. The drone will hover at that height.*
OR
2. From Idle mode, gently advance the throttle up to a desired
height and release. The drone will hover at that height.*
LANDING
1. Press the landing button to lower
the drone to the ground.
OR
2. Push down on the throttle until
the drone is on the ground.
NOTE:
* The drone may drift a bit, especially in the first 30 seconds until the altitude
sensor gets a good fix on the position. Some drift is normal.
- The engine will shut off if you choose to hold the
throttle down for 3 seconds.
- Emergency Shut Off: When in flight, pull the
throttle and direction stick to the center at
the same time and the drone will shut off.
Emergency Shut Off only works at altitudes under 10 feet.
UP
DOWN
9