Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Protocol neo-drone AP
Summary of Contents for Protocol neo-drone AP
- Page 1 NEO-DRONE AP MINI RC STUNT DRONE INSTRUCTION MANUAL...
- Page 3 THANK YOU. Thank you for your purchase of Protocol’s Neo-Drone AP Mini RC Stunt Drone. You are about to experience the best of what remote control flight has to offer. We strongly recommend that you take the time to read this manual thoroughly. It contains many tips and instructions on how to get the most out of this aircraft and maintain it for a long life.
-
Page 4: Table Of Contents
TABLE OF CONTENTS Safety & Precautions Parts Battery Installation Charging the Drone Start-Up Procedure Operation Tips on 3D Stunt & Tumbling Speed Modes Trim Adjustment Troubleshooting Flying Outdoors & Training Loop Replacement Parts & Limited Warranty... - Page 5 • Never attempte to modify function of vehicle or controller or attempt • repairs using parts other then those supplied by Protocol. Spare parts are available at www.ProtocolNY.com THIS DEVICE USES COMPONETS THAT OPERATE AT HIGH SPEEDS. AS WITH ANY SUCH DEVICE, USE CAUTION TO OPERATE SAFELY.
-
Page 6: Parts
PARTS DRONE 1. Canopy 2. Blade Guard 3. Blade 4. Landing Gear 5. Charging Jack... - Page 7 PARTS REMOTE SPARE PARTS INCLUDED 1. Indicator Light Replacement Blades 2. Flip 3. Direction Lever 4. Trim Forward/Backward 5. Trim Bank Left/Right 6. Throttle 7. ON/OFF Switch 8. High/Med/Low Speed Selector 9. Auto Take-Off 10.Auto Landing 11.Unlock/Emergency Stop...
-
Page 8: Battery Installation
REMOTE BATTERY INSTALLATION Take out the cover Install 3 x ‘AAA’ battery according to the correct polarities. Replace the cover 1. Install batteries carefully. 2. Do not mix old and new batteries. 3. Do not mix different types of batteries. -
Page 9: Charging The Drone
CHARGING THE DRONE BATTERY 1. Make sure the drone is turned off. 2. Connect the USB charging cable to the drone. 3. Plug the charger into a USB port. The USB light will turn off while charging and will turn on once fully charged. Charging time: approximately 30 minutes --- Flying time: approximately 6 minutes *Battery: Li-Po, 3.7V, 150mAh... -
Page 10: Start-Up Procedure
1. Turn on the controller; if, after 30 seconds, it has not recognized the drone, turn off the controller to retry synchronization. 2. If the Neo-Drone AP is unsteady in flight, it may not have been able to sync horizontally. Power down both drone and remote and restart pre-flight procedure. -
Page 11: Operation
OPERATION TAKE– OFF 1. Press the take off button. The remote will beep and the drone will hover a few feet off the ground. Then gently advance the throttle to a desired height and release. The drone will hover at that height.* 2. - Page 12 OPERATION FIRST TIME FLYERS!!! TAKE YOUR TIME! GO SLOW! Practice hovering until you are comfortable with flight before attempting any other maneuvers. Make small movements letting the stick return to the center. If you start to lose control, don’t panic. Just press land. LEFT ROTATION RIGHT ROTATION Pull the throttle left or right,...
-
Page 13: Tips On 3D Stunt & Tumbling
TIPS ON 3D STUNT & TUMBLING Once you are familiar with the basics of drone flight, you can try some advanced maneuvers! At a height of at least 10 feet, press the Flip button. The remote will beep and you are ready to execute a flip. LEFT FLIP Push the direction stick to the left and the drone will perform a 360°... - Page 14 TIPS ON 3D STUNT & TUMBLING FORWARD FLIP Push the direction stick forward and the drone will perform a 360° flip in that direction. BACKWARD FLIP Push the direction stick backward and the drone will perform a 360° flip in that direction.
-
Page 15: Speed Modes
SPEED MODES The Neo-Drone AP features 3 speed modes. Low speed is at 40%, Medium is at 70%, and High is at 100%. Choose the speed based on flight experience and level of comfort. Press the Speed button to change speed. The remote control indicator will beep... -
Page 16: Trim Adjustment
TRIM ADJUSTMENT LEFT MOVEMENT RIGHT MOVEMENT SIDEWAYS TRIM When the drone veers to the left or right side unintentionally, you can correct it by pressing the trim button in the opposite direction until it evens out. BACKWARD FORWARD FORWARD/BACKWARD TRIM When the drone veers forward/backward unintentionally, you can correct it by pressing the trim button in the opposite direction until it evens out. -
Page 17: Troubleshooting
Failure to do so could wear out and shorten the life of the motors. SYMPTOM POSSIBLE CAUSE POTENTIAL SOLUTION Neo-Drone AP 1. Communication between 1. To synchronize, turn on aircraft, does not controller and aircraft was not... - Page 18 FLYING OUTDOORS HOW TO PREVENT FLY AWAYS To prevent “fly-away” situations (where drones seem to fly away out of control) it is important to first test and practice within close range before letting the drone fly too far away. Each drone is designed to turn off the engines if the radio signal is lost. It is important to know and test the range of your drone before flying.
- Page 19 REPLACEMENT PARTS Thank you for your purchase of Protocol’s Neo-Drone AP Mini RC Drone. We know that accidents can sometimes happen and that is why we offer spare parts kits on our website: ProtocolNY.com. LIMITED WARRANTY At Protocol, we’re dedicated to bringing you innovative and well-designed products that make living fun and easy.
Need help?
Do you have a question about the neo-drone AP and is the answer not in the manual?
Questions and answers