Advertisement
Advertisement
Related Manuals for Protocol VENTO WIFI
Summary of Contents for Protocol VENTO WIFI
- Page 1 VENTO WIFI DRONE WITH LIVE STREAMING CAMERA INSTRUCTION MANUAL...
- Page 3 THANK YOU. Thank you for your purchase of Protocol’s Vento Wifi Drone with Live Streaming Camera. You are about to experience the best of what remote control flight has to offer. We strongly recommend that you take the time to read this manual thoroughly. It contains many tips and instructions on how to get the most out of this aircraft and maintain it for a long life.
-
Page 4: Table Of Contents
TABLE OF CONTENTS Safety & Precautions Parts Opening the Drone, Installing the Remote Batteries and Phone Charging the Drone Start-Up Procedure Operation Speed Modes Trim Adjustment Troubleshooting Flying Outdoors Replacement Parts & Limited Warranty... - Page 5 • Never attempte to modify function of vehicle or controller or attempt • repairs using parts other then those supplied by Protocol. Spare parts are available at www.ProtocolNY.com THIS DEVICE USES COMPONETS THAT OPERATE AT HIGH SPEEDS. AS WITH ANY SUCH DEVICE, USE CAUTION TO OPERATE SAFELY.
-
Page 6: Parts
PARTS DRONE 1. Canopy 2. Blade 3. Battery Compartment 4. Camera 5. Power Button (hold for 3 seconds when turning on and off) - Page 7 PARTS REMOTE SPARE PARTS INCLUDED 1. 2.4G Antenna Replacement Blades 2. Power Switch Screwdriver 3. Forward/Backward 4. Bank Left/Right 5. Throttle 6. Turn Left/Right 7. Speed Mode Selector 8. Take Off/Landing 9. Trimmer 10. Compass Mode 11. Battery Cover 12. Phone Mount...
- Page 8 REMOTE BATTERY AND PHONE INSTALLATION OPENING THE DRONE Follow the images below to unfold and pull out the arms. You will hear a click as each arm fully extends. INSTALLING THE BATTERIES Remove battery cover from controller. Insert 4 x ‘AA’ batteries according to indicated polarities.
-
Page 9: Charging The Drone
CHARGING THE DRONE BATTERY 1. Make sure the drone is turned off. 2. Pull out the cartridge battery from the drone. 3. Connect the USB charging cable to the battery. 4. Plug the charger into a USB port. The USB light will stay red while charging and will turn green once fully charged. -
Page 10: Start-Up Procedure
START-UP PROCEDURE Before flying, the drone and transmitter must be turned on in sequence and synchronized. 1. Turn on the drone by pressing the on button and holding for 3 seconds. The lights on the drone will flash to indicate it’s on. Place it on an even surface. The green lights on the drone are at the front and the red are at the back. - Page 11 START-UP PROCEDURE COMPASS MODE Users have the option to exit the default orientation (green lights at the front, red lights at the back). In Compass Mode, users can operate the drone without orientation. Regardless of where the drone is pointing, it will turn left or right according to the remote’s command.
-
Page 12: Operation
OPERATION: FLYING THE DRONE TAKE–OFF: 1. Press the take off button. The remote will beep and the drone will hover a few feet off the ground. Then gently advance the throttle to a desired height and release. The drone will hover at that height.* 2. - Page 13 OPERATION: FLYING THE DRONE FIRST TIME FLYERS!!! TAKE YOUR TIME! GO SLOW! Practice hovering until you are comfortable with flight before attempting any other maneuvers. Make small movements letting the stick return to the center. If you start to lose control, don’t panic. Just press land. LEFT ROTATION RIGHT ROTATION Pull the throttle left or right,...
-
Page 14: Speed Modes
At higher speeds, the drone will pitch more than at lower speeds. Vento Wifi is quite fast at its highest speed and requires more piloting skills to fly competently. For safety take time to develop advanced skills by practicing at lower speeds first. -
Page 15: Trim Adjustment
TRIM ADJUSTMENT *The button will be on your left as you are flying the drone and have the remote in hand. **The remote will beep as you are pressing the trim button. LEFT MOVEMENT RIGHT MOVEMENT SIDEWAYS TRIM When the drone drifts to the left or right side unintentionally, you can correct it by holding down the trim button and pushing the direction stick in the opposite direction until it evens out. -
Page 16: Troubleshooting
TROUBLESHOOTING LOW BATTERY ALARM The remote will start to beep in flight and the lights will flash when the battery is low. Land the drone as soon as possible and recharge the drone. OUT OF RANGE ALARM When the drone is close to flying out of range, the remote will beep rapidly. Fly the drone back into range immediately or you may lose control of the drone. - Page 17 Failure to do so could wear out and shorten the life of the motors. SYMPTOM POSSIBLE CAUSE POTENTIAL SOLUTION Vento Wifi 1. Communication between 1. To synchronize, turn on aircraft does not controller and aircraft was not...
-
Page 18: Flying Outdoors
FLYING OUTDOORS HOW TO PREVENT FLY AWAYS To prevent “fly-away” situations (where drones seem to fly away out of control) it is important to first test and practice within close range before letting the drone fly too far away. Each drone is designed to turn off the engines if the radio signal is lost. It is important to know and test the range of your drone before flying. - Page 19 REPLACEMENT PARTS Thank you for your purchase of Protocol’s Vento Wifi. We know that accidents can sometimes happen and that is why we offer spare parts kits on our website: www.ProtocolNY.com. LIMITED WARRANTY At Protocol, we’re dedicated to bringing you innovative and well-designed products that make living fun and easy.
Need help?
Do you have a question about the VENTO WIFI and is the answer not in the manual?
Questions and answers