Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Protocol VIDEODRONE FX
Summary of Contents for Protocol VIDEODRONE FX
- Page 1 VIDEODRONE fX DRONE with camera INSTRUCTION MANUAL...
- Page 2 THANK YOU. Thank you for your purchase of Protocol’s VideoDrone FX With Camera. You are about to experience the best of what remote control flight has to offer. We strongly recommend that you take the time to read this manual thoroughly. It contains many tips and instructions on how to get the most out of this aircraft and maintain it for a long life.
-
Page 3: Table Of Contents
TABLE OF CONTENTS Safety & Precautions Parts Remote Battery Installation Installing the Blade Guard Charging the Drone Turning On & Syncing the Drone Operation Tips on 3D Stunt & Tumbling High, Medium, & Low Speed Modes Trim Adjustment Troubleshooting Flying Outdoors Shooting Photo/Video Replacement Parts &... -
Page 4: Parts
PARTS PARTS DRONE REMOTE 1. Canopy 1. 2.4G Antenna 2. Blade Guard 2. Power Switch 3. Blade 3. Trim Forward/Backward 4. Battery Compartment 4. Flip 360° 5. Camera 5. Forward/Backward 6. Bank Left/Right 7. Video 8. Photo 9. Trim Bank Left/Right 10. -
Page 5: Remote Battery Installation
REMOTE BATTERY INSTALLATION INSTALLING THE BLADE GUARD If not already installed, install the included blade guards to every corner by snapping them in and tighten the screws at the base. NOTE: If the drone crashes, double check to make sure the blade guard is not loose. -
Page 6: Charging The Drone
NOTE 3. In order to increase battery longevity, avoid repeat charging and 1. If the VideoDrone FX and the remote do not sync after following the excessive discharging. checklist, reverse steps 1 and 2 of the process. Turn the remote and the drone off. -
Page 7: Operation: Flying The Drone
OPERATION: FLYING THE DRONE OPERATION: FLYING THE DRONE FIRST TIME FLYERS!!! Do not push the throttle up all the way. Before taking off, gently push the throttle up to the point where the blades are spinning but the drone is not in flight. -
Page 8: Tips On 3D Stunt & Tumbling
TIPS ON 3D STUNT & TUMBLING TIPS ON 3D STUNT & TUMBLING Once you are familiar with the basics of drone flight, you can try some advanced maneuvers! At a height of at least 10 feet, press the Flip 360° button and move the direction lever in any desired direction to execute the flip. -
Page 9: High, Medium, Low Speed Modes
HIGH, MEDIUM, LOW SPEED MODES TRIM ADJUSTMENT The VideoDrone FX features 3 speed modes. Low speed is at 40%, Medium is at 70%, and High is at 100%. Choose the speed based on flight experience and level of comfort. Press the Speed +/- button to change the speed mode. The remote control indicator will beep once for low speed, twice for medium, and three times for high. -
Page 10: Troubleshooting
TROUBLESHOOTING FLYING OUTDOORS *Allow 15 minutes to pass between full flights as this will give the motors a HOW TO PREVENT FLY AWAYS chance to cool down. Failure to do so could wear out and shorten the life To prevent “fly-away” situations (where drones seem to fly away out of of the motors. -
Page 11: Shooting Photo/Video
REPLACEMENT PARTS 1. The memory card comes pre-inserted into the camera. Thank you for your purchase of Protocol’s VideoDrone FX with Camera. We know that accidents can sometimes happen and that is why we offer spare parts kits on our website: ProtocolNY.com.
Need help?
Do you have a question about the VIDEODRONE FX and is the answer not in the manual?
Questions and answers