Mounting The 8010Co Chassis In A 19-Inch Rack - Nortel Passport 8000 Series Installing And Maintaining

Mounting the 8010co chassis in a 19-inch rack

To install the 8010co chassis in a 19-inch two-post rack:
1
Place the installation shelf at the bottom of the rack inside the rails.
2
Holding the installation shelf in position, align the shelf's mounting rail with
two holes on each side of the vertical rack support.
3
Insert a Phillips screw through each installation shelf mounting hole and into
the corresponding hole in the rack
4
Add a hex nut to each screw and tighten using a hex wrench.
5
Tighten each screw with a Phillips screwdriver.
6
If the holes in the rack's vertical supports requires clipnuts, insert a clipnut in
12 locations.
7
Lift the 8010co chassis onto the installation shelf.
Warning: It requires three people to lift the 8010co chassis. You must
remove the I/O modules and power supplies before lifting.
8 Holding the 8010co chassis in position, align the flanged end of the chassis
mounting rail with six holes on each side of the vertical rack support
(Figure 31 on page
9 Make sure that the hole pairs on either side of the vertical support match
horizontally.
10 Tighten each screw with a Phillips screwdriver.
Chapter 3 Installing the 8010co chassis 61
(Figure 30 on page
63).
Installing and Maintaining the Passport 8000 Series Chassis
62).