8010Co Chassis - Nortel Passport 8000 Series Installing And Maintaining

24 Chapter 1 Passport 8000 Series chassis hardware components

8010co chassis

As shown in
Passport 8600 interface modules and two slots for installing the 8691SF or
8692SF switch fabric modules. Slots are numbered from left to right. You can
install Passport 8600 interface modules in slots 1 through 4 and slots 7 through 10.
Slots 5 and 6 are reserved for Passport 8000 Series switch fabric modules. For
complete information about Passport 8600 modules and instructions for installing
them, see Installing Passport 8600 Switch Modules (312749-J).
The 8010co chassis has three bays for either AC or DC power supplies. The
8010co chassis supports the following AC power supplies:
•
•
The 8010co chassis supports the following DC power supplies:
•
•
316314-E Rev 01
Figure 1, the 8010co chassis provides eight slots for installing
8004AC
8005AC
8004DC
8005DC
Caution: The 8004 and 8005 power supplies have different power
ratings. Therefore, Nortel Networks recommends that you do not operate
the Passport 8000 Series chassis with a mix of power supply models
(8004, and 8005).
If you are upgrading the Passport 8600 switch and have a redundant
power configuration, you can hot-swap the 8004 power supply with the
8005 power supply while the Passport 8000 system remains in operation.
Do not operate the chassis with a mix of power supply models for an
extended period of time.
Upgrade the power supplies before upgrading the modules.