Mounting the 8010co chassis in a two-post rack
To mount the 8010co chassis in a two-post rack, you need the following
equipment:
•
Installation shelf (shipped with the 8010co chassis)
•
A standard 19-inch or 23-inch equipment rack
Attach the clipnuts shipped with the 8010co chassis if necessary.
Note: To install the 8010co chassis in a 23-inch equipment rack refer to
the rack manufacturer's 19-to-23-inch adapter installation instructions.
The hardware required for mounting the chassis in a rack depends on your rack
type. Use the 12 Phillips screws and a Phillips screwdriver to intall the chassis in a
standard rack. Use the 12 hex head screws and a nutdriver to install the chassis in
a Hendry rack.
In a 7-foot two-post rack, you can install two 8010co chassis platforms and a BIP.
Figure 29 on page 60
rack.
Chapter 3 Installing the 8010co chassis 59
shows two 8010co chassis with a BIP installed in a two-post
Installing and Maintaining the Passport 8000 Series Chassis