8010 Chassis - Nortel Passport 8000 Series Installing And Maintaining

26 Chapter 1 Passport 8000 Series chassis hardware components

8010 chassis

As shown in
installing interface modules and two slots for installing Passport 8691SF or
8692SF switch fabric modules. Slots are numbered from the top down. You can
install Passport 8600 interface modules in slots 1 through 4 and slots 7 through 10.
Slots 5 and 6 are reserved for Passport 8600 Series switch fabric modules.
For complete information about Passport 8600 modules and instructions for
installing them, see Installing Passport 8600 Switch Modules (312749-J).
The 8010 chassis has three bays for either AC or DC power supplies. The 8010
chassis supports the following AC power supplies:
•
•
•
The 8010 chassis supports the following DC power supplies:
•
•
•
316314-E Rev 01
Figure 2 on page
8001AC (discontinued)
8004AC
8005AC
8002DC (discontinued)
8004DC
8005DC
Note: The 8001AC and 8002DC power supplies have not been tested
with Passport 8600 modules released since Passport 8600 Release 3.7.
Therefore, Nortel Networks recommends that you use the 8004 or 8005
power supply with these modules.
28, the 8010 chassis provides eight slots for