Table of Contents
Advertisement
2
Getting Started
2.3 Inserting & removing the rubber armour/stand
Before removing the meter from the rubber armour, disconnect any electrodes.
Push out from the bottom edges of meter until it is completely out of boot.
To insert meter into the armour, slide in from the top of meter before pushing
the bottom edges of meter into position. Tilt the stand at the back of meter
for table top usage as desired.
2.4 Inserting New Batteries
The "LO" annunciator alerts you when battery power is running low. Power off
the meter before removing the batteries. After removing the rubber armour, push
the battery cover in the direction of the arrow and lift up - no screwdriver
is required. Note the polarity of batteries before inserting into position.
6
Advertisement
Table of Contents
