Connecting Electrodes And Temperature Sensor; Powering The Meter On - palintest Micro 600 Manual

Ph meter

Hide thumbs Also See for Micro 600:

Table of Contents

Getting Started

2.5 Connecting Electrodes and Temperature Sensor

Align the BNC connector slots with the posts

2.5mm Phono plug for

temperature measurement

of meter's socket and rotate connector

clockwise until it locks - do not force. To

BNC

connector of

remove, rotate the connector in counter-

pH, ORP, or

clockwise direction until it unlocks, and slide

Ion Selective

Electrode

the connector off the socket. Insert the mini

phono jack of temperature sensor into the

socket on the meter. Unplug the phono

jack to perform measurements without

temperature compensation (25°C default).

Press ON/OFF. All LCD segments will display momentarily during the self-

diagnostic test, before scrolling the model number, software revision, pH

buffer group, and number of pH calibration points selected before returning

to the measurement mode:

If a temperature probe is not connected, either 25.0ºC (factory default) or the

last calibrated temperature value is used. If a temperature probe is connected,

the current measured temperature is used.

"Or" (Over range) and "Ur" (Under range) indicates the reading exceeds the

maximum or minimum measurement range. See Section 6 - Specifications.

However, the most likely reason for these error messages is that the electrode

is not connected or broken.

Table of Contents